DIY Sign Kits

Self-Adhesive Sign Kits...

Order your self-adhesive vinyl graphics simply on line just by sending us an email.

 

Tell us what you want to put on your sign and we will send a proposed design with price estimate. Once you have approved the design we will send the graphics by post for you to apply yourself. Graphics can include logos and clipart images.

 

Text is supplied pre-spaced and ready to apply to your own surface, board, window, vehicle etc.

Application Instructions.

Avoid applying text and graphics in cold conditions.

1. Position the graphic on a clean but not polished surface.

2. When the graphic is level apply tape along the top edge to create a hinge.

3. With larger graphics, cut into sections so that you apply one or several letters at a time. This is easier than trying to apply the whole thing in one go.

4. Lift the bottom edge of the graphic and, starting in one corner, carefully peel away the backing paper leaving the letters attached to the transfer paper.

5. Hold the bottom of the transfer paper and press the letters down using short vertical strokes, starting from the top.

6. Remove the transfer paper carefully to leave the graphic behind.

 

Wet Application

For larger letters, or just to make life easier, wetting the back of the letters slows down the adhesion of the vinyl, allowing repositioning in case of a slip up.

 

Method

  • Proceed as for the dry method but between steps 2 and 3 spray the rear of the letters with water mixed with a few drops of washing up liquid.
  • Delay stage 5 a few moments, as the water has to dry enough for the letters to remain fixed.
  • Smooth out any bubbles. others may appear later but will disappear on their own.